Label

Jelly Bean 4.1.2 Motorola Droid Razr and Droid Razr Maxx Leak Available for Download.



There is a leaked Jelly Bean out for Original Droid Razr/Maxx.  I have tested it and runs smooth.  So far I have not ran into any bugs.  It takes about 15-30 mins to do the upgrade.  Follow the instructions below to get the jelly bean goodies for your Razr. 

NOTE:  Like always we or this site are NOT responsible for anything that happens to your phone during this process. Knowing that you are continuing with these instructions solely on your behalf. 



Download The following file:

Download: Jelly Bean Leak

Make sure to put this file on the root of your sdcard, meaning not inside any folders.  The "root directory" is the directory you connect to when you first connect to the SD card when you connect it to your computer 

Instructions:

Step1: Bootloader/Boot Mode Selection Mode

1.Power Off the Razr, by pressing the power button and selecting “power off.”

2.Press and  hold both volume buttons + -, and then press the power button to power on the device.

3.When you see the Boot Mode Selection Menu let go of all the buttons.

4.Press the volume down to select Recovery and then press Volume Up (to Make selection).

5.From the screen with the half-dead looking Android guy, press volume up and volume down again (at the same time)

6.Use the volume up and volume down buttons to navigate the menus, and the power button to make your selection.




Step2: Flashing Jelly Bean

1. Now that your are in Recovey, select "install update from external sdcard."  
And pick the file you download above Blur_Version.6.16.211.XT912.Verizon.en.US.zip


2. Wait for the update to finish installing (about 20-30 minutes.)

3. After the update is finished, simply reboot the phone.

4.  If everything goes well, then enjoy.


Posted by Sans | Published at 3:58 AM

No comments :

Post a Comment

 
 
Copyright © 2014 All About Android Template Design By | Pathmo